[izzy wizzy]

Have been using LTSPICE for ages and when using the .op command, the results appear in a window. Except for one circuit I sim'd and the .op command doesn't produce the window but the .raw graph as if it was a .tran or .ac. When you click on the circuit with the probe or current meter the results appear on the .raw graph which is kinda nice.

Why is this and how can I repeat it for other sims?

cheers,

Stephen

[dave slagle]

Hey,

Are you by chance stepping a parameter? That gives you a graph rather than a printout.

dave

[izzy wizzy]

Yes I was stepping a parameter I didn't think of that as the param I was stepping wasn't on the circuit i.e. it was a hangover from when that component was there and now it isn't.

cheers,

Stephen